mopwicked.blogg.se - Sentry safe open combination buttons

#SENTRY SAFE OPEN COMBINATION BUTTONS INSTALL#
#SENTRY SAFE OPEN COMBINATION BUTTONS MANUAL#

To erase the passcode, press Program twice, enter your User Code and then enter 00000.) Unlocking (To enter a new passcode, repeat these steps.

Enter the 5-digit passcode of your choice (any combination except 00000.) After 5 digits are entered, the green LED turns OFF.

(To enter a new User Code, repeat these steps.) Programming a passcode The lock will “beep” and the green LED will come on. (To enter a new User Code, repeat these steps.) After 5 digits are entered the green LED turns OFF. The green LED remains ON while you enter the 5-digit user code of your choice. There are two ways to program a user code. If you wish to give someone else temporary access to the safe, you can program a passcode that can later be erased. But if you prefer to use your own code, you can program the safe to open to the 5-digit User Code of your choice.

You can always open the safe by entering the 5-digit Factory Code. There are three possible ways to unlock and access the safe-by entering its preset Factory Code, your own User Code or a Passcode. If you pause longer, an error signal will occur (blinking red light and three beeps), indicating you should start over. The lock allows 5 seconds for each key press. A green PROCEED light and a single beep indicate that the keypad “felt” your touch.

For units with key, turn the key to the right.(Be sure key lock is turned as far left as possible.) Insert the four-bitted key into the lock to the left of the key pad.Some electronic units are equipped with a handle OR electronic lock and key. NOTE: All electronic lock units have been provided with an override key (skeleton key). Test your combination several times with the door open.

#SENTRY SAFE OPEN COMBINATION BUTTONS MANUAL#

(See back cover of this manual for your factory code.) B) Insert the four batteries as indicated. Remove key hook plate located on the inside back of the door by sliding the plate upward, then pulling toward you. A) Unlock door with the override key provided in the plastic bag attached to the owner’s manual, and open the door using the lever handle.

#SENTRY SAFE OPEN COMBINATION BUTTONS INSTALL#

To install batteries, remove keypad by rotating the cover counterclockwise, then pulling toward you.